Abstract:
In this work, the 70/30 and 30/70 w/w polycaprolactone (PCL)/polybutylene succinate
(PBS) blends and their corresponding PCL/PBS/(polycarbonate (PC)/multiwalled carbon nanotubes
(MWCNTs) masterbatch) nanocomposites were prepared in a twin-screw extruder. The
nanocomposites contained 1.0 and 4.0 wt% MWCNTs. The blends showed a sea-island morphology
typical of immiscible blends. For the nanocomposites, three phases were formed: (i) The matrix (either
PCL- or PBS-rich phase depending on the composition), (ii) dispersed polymer droplets of small
size (either PCL- or PBS-rich phase depending on the composition), and (iii) dispersed aggregates
of tens of micron sizes identified as PC/MWCNTs masterbatch. Atomic force microscopy (AFM)
results showed that although most MWCNTs were located in the PC dispersed phase, some of them
migrated to the polymer matrix. This is due to the partial miscibility and intimate contact at the
interfaces between blend components. Non-isothermal di erential scanning calorimetry (DSC) scans
for the PCL/PBS blends showed an increase in the crystallization temperature (Tc) of the PCL-rich
phase indicating a nucleation e ect caused by the PBS-rich phase. For the nanocomposites, there was
a decrease in Tc values. This was attributed to a competition between two e ects: (1) The partial
miscibility of the PC-rich and the PCL-rich and PBS-rich phases, and (2) the nucleation e ect of the
MWCNTs. The decrease in Tc values indicated that miscibility was the dominating e ect. Isothermal
crystallization results showed that the nanocomposites crystallized slower than the neat blends and
the homopolymers. The introduction of the masterbatch generally increased the thermal conductivity
of the blend nanocomposites and a ected the mechanical properties.
